Please help me! I have a 1600 series router, don't ask why, but I changed the config-register to 0x3922 and hit reload. Big mistake!
All that I can now see is X across my terminal session. I have tried changing the console baud rate to 115200 but the problem persists! Can anyone please tell me how to resurect the box? The router has know config so I cannot telnet onto it.
Prashanth, thank you so very much! I'm slightly confused why setting the baud rate to 2400 worked though. I thought that by using a config-register to 0x3922, I would be setting the console port on the router to work at 115200?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...