This is possible using a DB60 crossover cable with one router providing clocking on the serial interface. However, keep in mind that the max throughput on a synchonous serial interface is 2 Mbps for the 1600 series. At least that's what I remember. You can determine that maximum clock rate the router supports by going into the router's serial interface and type "clock rate ?". It's either 2 Mbps or 4 Mbps. Won't keep up with a 10 Mbps port but it will work.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...