Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1601

Hey All

I need the commands to set the interface E/0 to full duplex, this is on a Cisco 1601 running software version 11.3

Also on this router the E/0 connects to a CISCO 2924 switch that I have a VLAN running, now the question I have a remote LAN connected to the serial T-1 port does the remote LAN need membership to the VLAN?

1 REPLY

Re: 1601

Hi,

1) AFAIK, full duplex is not supported on a Cisco 1601 running software version 11.3.

2) Is my understanding correct there is an 2924 access port assigned to some VLANx connected to your 1601 E0 port? You don't have to care about VLANs on the router then - frames are coming untagged to your E0 port and are routed to/from T1 port.

Regards,

Milan

97
Views
0
Helpful
1
Replies