Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1602 boots to rmon then can boot straight to IOS with manual command

I have a 1602 R that boots to rmon mode when power on reset is performed. Can boot straight to IOS from the rmon prompt. Config reg 0x2102 looks ok as well as system boot flash:c1600-y-mz.120-12 command. Does anyone know if I'm missing something in the boot setup or has anyone seen this problem before? I do have a modem setup on the console port for remote managment.

Cisco Internetwork Operating System Software

IOS (tm) 1600 Software (C1600-Y-M), Version 12.0(12), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2000 by cisco Systems, Inc.

Compiled Mon 10-Jul-00 19:59 by htseng

Image text-base: 0x02005000, data-base: 0x0245E484

ROM: System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1)

ROM: 1600 Software (C1600-RBOOT-R), Version 12.0(3)T, RELEASE SOFTWARE (fc1)

Name Removed uptime is 4 days, 3 hours, 11 minutes

System restarted by abort at PC 0x20E7908

System image file is "flash:c1600-y-mz.120-12"

cisco 1602 (68360) processor (revision C) with 6144K/2048K bytes of memory.

Processor board ID 22641869, with hardware revision 00000004

Bridging software.

X.25 software, Version 3.0.0.

1 Ethernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

On-board Switched 56K Line Interface.

System/IO memory with parity disabled

8192K bytes of DRAM onboard

System running from RAM

7K bytes of non-volatile configuration memory.

4096K bytes of processor board PCMCIA flash (Read/Write)

Configuration register is 0x2102

2 REPLIES

Re: 1602 boots to rmon then can boot straight to IOS with manual

Could be an electrical issue with capacity that draws a line low for long enough to be seen as a BREAK. Try to boot without the modem attached and see if the problem goes away.

New Member

Re: 1602 boots to rmon then can boot straight to IOS with manual

I was thinking along the same lines. The site was a production site and I had a tech swap aout the hardware and when the problem didn't go away I had them send it to me to test in the lab. I'll post the results.

265
Views
0
Helpful
2
Replies