I having problems with one of my routers, every time I try to boot the router I get an error about the flash. I think that my config file that was on the flash was erased. I want to find out how can I boot my router from a tftp or any other solutions to get the boot configuration back on it. The confusing part is that Im getting a lot of character, from the router every time I turn it on in the HyperTerminal, even when I have the right configuration in the Hyper Terminal for the Cisco equipment.
Did you happen to change the configuration register? Reboot the router and check at bootup to see what the configuration register is set at. You may need to drop your Hyperterminal bits per second rate down to 2400. I seem to remember having a problem similar to this with an AS2509 and that is what I had to do. Good luck.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...