You can probably use 'backup interface' to configure dialer0 to backup the ADSL. And then, use a route-map with the 'match interface' command to do the translation based on the interface out of which the packet is sent.
You can use route-maps with NAT if you are running Cisco IOS Software Release later than 12.1. Below is an example of what the configuration should be. This is just an example and will probably not have your exact network IP scheme in it. Here is a URL that may help as well.
PBR only works when defining different parameters in the ACLs such as SA or DA, in this case the SA (Ethernet IP host) and DA (Remote Router) are the same. PBR cannot differentiate between the two route-maps and continues to xlate to the outside address of the interface in the lowest numbered NAT ID.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.