I am setting up a small network of pc's. I want to share the internet with all of the workstations via a cable modem. I have a 1720 router with a t1 wic card in it. Will it work with the current hardware config or will I need to get additional hardware?
Re: 1720 router and cable modem! is it possible???
I think you'll need something with two ethernet interfaces. If you have limited IP Addresses, you may need to do something like NAT, in which case the Cisco way to go is a PIX 506. If you're OK with the number of IP Addresses the service provider will give, then probably just a hub/switch attached to the cable modem is the way to go.
Is this for home use, small branch, etc? What's the application here?
I'm working on a project that includes basic router configurations. I configurated everything including: line console 0, line vty 0 15 and secret passwords. There are 3 routers in the network and every LAN is going t...