I am setting up a small network of pc's. I want to share the internet with all of the workstations via a cable modem. I have a 1720 router with a t1 wic card in it. Will it work with the current hardware config or will I need to get additional hardware?
Re: 1720 router and cable modem! is it possible???
I think you'll need something with two ethernet interfaces. If you have limited IP Addresses, you may need to do something like NAT, in which case the Cisco way to go is a PIX 506. If you're OK with the number of IP Addresses the service provider will give, then probably just a hub/switch attached to the cable modem is the way to go.
Is this for home use, small branch, etc? What's the application here?
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...