Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

1720 Routers over 2 x BT EPS9 (Baseband) lines using WIC-2T ???

We currently have two Cisco 1720 routers running IOS 12.2(11), connect to each other over a BT Baseband line. The speed on this line is limited to 2MB, we are therefore getting a second line installed, and want to combine the two lines.

I just wanted to double check that this could be done using the following:

WIC-2T - 2 port serial card.

Have each serial port running to a separate Line Driver, and configure the routers to use Multilink via virtual.

Any advice appreciated.

Thanks

Daniel

1 REPLY

Re: 1720 Routers over 2 x BT EPS9 (Baseband) lines using WIC-2T

Hi

Ofcourse u can bundle the E1s connecting on the WAN ports using multilink bundle.

Also u can try out normal load balancing via both the links using normal static routes.

i m not sure what do u mean by "Seperate Line Driver here" ....

regds

169
Views
0
Helpful
1
Replies
CreatePlease to create content