01-29-2004 10:03 AM - edited 03-02-2019 01:14 PM
Im am trying to configure a 1721 router. It was configured before. I am not able to enter any commands such as end, enable, configure.... I get the prompt monitor:command "exit" not found. The next line comes up as rommon 3 > and anything entered gets the same response....What am I doing wrong??? I turned off power and restarted it to see if it would reset, but no luck.
01-29-2004 11:34 PM
ROmmon means it has started without ios software or wrong config register.you need to get the ios in flash or booted from flash by means of rommon witch is basicly a limited os.
http://www.cisco.com/en/US/products/hw/routers/ps221/products_tech_note09186a00800942dc.shtml
01-30-2004 05:07 AM
Thanks for the help!!!
01-30-2004 05:53 AM
no problem :-)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide