Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

1750 router with wic-1enet

I have a cisco 1750 router. I just got a wic-1enet card for it. the router meets all the requirements for the card, and the slot 0 ok led is on. when I log into the console port and do "show interfaces" all I get is the fast ethernet that is onboard, and loopback0. ethernet 0 doesn't show up in there. am I doing something wrong or is there something I can do to try and fix the problem?

  • Other Network Infrastructure Subjects
3 REPLIES

Re: 1750 router with wic-1enet

Please do a show version and check if your ethernet card is listed there. If yes, then the router is recoznising the card and try to reseat it again and possibly a reload after that. Try shut and no shut on the interface as well.

If no, then check the hardware/software requirement of the card.

Regards,

-amit singh

New Member

Re: 1750 router with wic-1enet

Cisco Internetwork Operating System Software

IOS (tm) C1700 Software (C1700-BNR2Y-M), Version 12.0(5)XQ, EARLY DEPLOYMENT REL

EASE SOFTWARE (fc1)

TAC:Home:SW:IOS:Specials for info

Copyright (c) 1986-1999 by cisco Systems, Inc.

Compiled Mon 09-Aug-99 13:53 by rnapier

Image text-base: 0x80008088, data-base: 0x807A7458

ROM: System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1)

ROM: C1700 Software (C1700-BNR2Y-M), Version 12.0(5)XQ, EARLY DEPLOYMENT RELEASE

SOFTWARE (fc1)

it doesn't show the ethernet card in the "show version" results. from everything I've read, in the manual and online, it says it should support the card, but only in slot 0.

New Member

Re: 1750 router with wic-1enet

show diag gives me this:

Slot 0:

C1750 1FE VE Mainboard port adapter, 1 port

Port adapter is analyzed

Port adapter insertion time unknown

EEPROM contents at hardware discovery:

Hardware revision 5.2 Board revision C0

Serial number 2660151875 Part number 73-3743-05

Test history 0x0 RMA number 00-00-00

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 C9 05 02 9E 8E B2 43 49 0E 9F 05 00 00 00 00

0x30: 60 00 00 04 00 00 00 00 00 00 00 00 00 00 00 00

WIC Slot 0:

Unknown WAN daughter card

Hardware revision 64.0 Board revision G0

Serial number 0960561920 Part number 130-18710-165

Test history 0x03 RMA number 66-65-48

Connector type PCI

EEPROM format version 4

EEPROM contents (hex):

0x20: 04 FF 40 00 39 41 03 00 82 49 16 A5 03 42 41 30

0x30: 80 00 00 00 00 02 02 C1 8B 56 4D 53 30 36 32 36

107
Views
0
Helpful
3
Replies