Have 1760 routers, with vwic t1, and f2xs card in them,
we have at&t bringing in a t1, we currently use 2 channels for data and voice (corporate pbx)we plan to use at&t to split another channel to each location for pots.. to use the 2nd port on the fxs card... need someone to let me know what i need to do in order to do this... what lines do i need to add to config in order for this to happen...
You will need few more dial-peer configurations for the second FXS port and to connect to other sites. You may also have to change the T1 configuration to accommodate the new channel. It is diffcult to arrive at the config without looking at the present configuration. You might however find similar examples on CCO.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...