cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
259
Views
0
Helpful
2
Replies

1760 IOS Version question

bobd
Level 1
Level 1

What version of the IOS do I need on a 1760 to support the dlsw and source-bridge commands? I'm currently running c1700-sy-mz.122-11.T2.bin (IP Plus), and it does not support the commands. Do I need to take it to the IP/ADSL Plus for these commands?

Bob

1 Accepted Solution

Accepted Solutions

rlcarr
Level 1
Level 1

Here are a couple of links that should help,

Cisco's Software Advisor - allows you to pick features and it will tell you which IOS you need.

http://www.cisco.com/cgi-bin/Support/CompNav/CN1.pl?HStartForm2=True

IOS Naming Conventions - shows which features are supported by the codes in the filename

http://www.cisco.com/warp/public/620/5.shtml

Hope this helps,

~rlc

CCNP, CCDA, CNE

View solution in original post

2 Replies 2

rlcarr
Level 1
Level 1

Here are a couple of links that should help,

Cisco's Software Advisor - allows you to pick features and it will tell you which IOS you need.

http://www.cisco.com/cgi-bin/Support/CompNav/CN1.pl?HStartForm2=True

IOS Naming Conventions - shows which features are supported by the codes in the filename

http://www.cisco.com/warp/public/620/5.shtml

Hope this helps,

~rlc

CCNP, CCDA, CNE

We all need a kick in the right direction now and again. The software Advisor did it for me here. At some point in the history of the IOS/model upgrades, IP Plus is no longer required to support the dlsw and source-bridge commands, but the IP/ADSL/IPX/AT/DEC does (at least for the 1760). It looks like IP Plus is still required for these commands on the 2500 series though. Thanks for the post.

Bob

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: