I have two 1760 routers each with a 1DSU T1 WIC card. I want to connect each T1 WIC so as to simulate a serial connection before I put the devices in production. Can anyone tell me the pin out for a RJ48c (if this is what I need) and the commands to setup the serial interface? Is it as simple as plugging an RJ48c between the two WICs and adding the correct config? I have tried making a RJ48c but the first router receives a CD light but the second does not.
I think you can have a T1 back-to-back connection with the following wiring schema using an RJ-45 connector, and then configure it with the appropriate channel-group command to simulate the serial connection.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...