Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

18 E1 throttles.

We have a new installed E3 circuit.

By doing "sh cont e3 0/0" i get a lot of data, alos the above mentioned message.

Is that anything to worry about?

Regards Karl-Heinz

1 REPLY
Bronze

Re: 18 E1 throttles.

Throttles is the number of times the receiver on the port was disabled, possibly due to buffer or processor overload. Here is a link that explains the output from the show controller e1 command:

http://www.cisco.com/warp/public/116/show_ce1.html

132
Views
0
Helpful
1
Replies
CreatePlease to create content