Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1841 Does Not Allow Browsing

I have a brand new 1841 that is not allowing any internet browsing. I can ping and tracert and resolve DNS, but all browsing comes back "page cannot be displayed".

I have the 4 port switch module in slot 0. We are using an XData line that comes into the router as ethernet.

I've attached my config, any help would be greatly appreciated.

2 REPLIES
VIP Purple

Re: 1841 Does Not Allow Browsing

Hello,

I think your access list 101 is blocking access to the Internet. A ´term mon´ should reveal that when you monitor your router. The access list should allow tcp port 80 (www) and 53 (dns) as well, can you try and add those ports, and check if that makes a difference ?

Regards,

GP

Hall of Fame Super Silver

Re: 1841 Does Not Allow Browsing

Larry

I have looked at the config that you posted and believe that I see your problem which is the access list that is applied inbound on interface vlan 1. Access list 101 is controlling traffic coming into the router if I understand your config correctly. And access list 101 has only 2 statements that permit any kind of tcp traffic:

access-list 101 permit tcp any range 1099 1102 any range 1099 1102

access-list 101 permit tcp any range 5631 5632 host 172.20.1.150 range 5631 5632

and neither of these permit HTTP traffic to get through the interface. I am not clear what the logic was in constructing this access list. But if you add a statement in the access list which permits HTTP traffic I believe that browsing will start to work.

HTH

Rick

130
Views
0
Helpful
2
Replies
CreatePlease login to create content