09-09-2006 08:07 PM - edited 03-03-2019 04:56 AM
Hi All,
I have problem where a newly purchased 1841 Router with base image will not recgonize an HWIC-1ADSL card. The error i'm getting when the router boots and the sh ver output is as follows:
0X00000000 UNKNOWN Card in slot 1
CARD_NOT_SUPPORTED: Slot 1: Unknown WAN daughter card
#sh ver
Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(1c), RELEASE SO
FTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Tue 25-Oct-05 17:10 by evmiller
ROM: System Bootstrap, Version 12.3(8r)T9, RELEASE SOFTWARE (fc1)
yourname uptime is 7 minutes
System returned to ROM by power-on
System image file is "flash:c1841-ipbase-mz.124-1c.bin"
Cisco 1841 (revision 6.0) with 114688K/16384K bytes of memory.
Processor board ID FTX1031Y02U
2 FastEthernet interfaces
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
31360K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
Any assistance is appreciated..
Don
09-09-2006 08:27 PM
Don,
HWIC-1ADSL on 1841 is supported only on 12.4(4)T and higher. Please refer the below URL for details.
http://www.cisco.com/en/US/products/ps5853/products_data_sheet0900aecd80394b7e.html
I hope it helps.
Regards,
Arul
09-09-2006 08:39 PM
Thanks for your reply. I'll try an updated software image and see how it goes..
Don
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: