Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1841 With HWIC-1ADSL

Hi All,

I have problem where a newly purchased 1841 Router with base image will not recgonize an HWIC-1ADSL card. The error i'm getting when the router boots and the sh ver output is as follows:

0X00000000 UNKNOWN Card in slot 1

CARD_NOT_SUPPORTED: Slot 1: Unknown WAN daughter card

#sh ver

Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(1c), RELEASE SO

FTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2005 by Cisco Systems, Inc.

Compiled Tue 25-Oct-05 17:10 by evmiller

ROM: System Bootstrap, Version 12.3(8r)T9, RELEASE SOFTWARE (fc1)

yourname uptime is 7 minutes

System returned to ROM by power-on

System image file is "flash:c1841-ipbase-mz.124-1c.bin"

Cisco 1841 (revision 6.0) with 114688K/16384K bytes of memory.

Processor board ID FTX1031Y02U

2 FastEthernet interfaces

DRAM configuration is 64 bits wide with parity disabled.

191K bytes of NVRAM.

31360K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102

Any assistance is appreciated..

Don

  • Other Network Infrastructure Subjects
2 REPLIES
Cisco Employee

Re: 1841 With HWIC-1ADSL

Don,

HWIC-1ADSL on 1841 is supported only on 12.4(4)T and higher. Please refer the below URL for details.

http://www.cisco.com/en/US/products/ps5853/products_data_sheet0900aecd80394b7e.html

I hope it helps.

Regards,

Arul

New Member

Re: 1841 With HWIC-1ADSL

Thanks for your reply. I'll try an updated software image and see how it goes..

Don

287
Views
5
Helpful
2
Replies