If i have 2 catalyst 6509 with (2) MSFCII modules and i use trunk to interconnect each other, how configure the DHCP server on the switches?
If I configure a DHCP pool for every VLAN on the 1st 6509 MSFCII how can i configure the 2nd 6509 MSFCII for DHCP "recovery" ?
If on the 1st 6509 i configure a DHCP Database Agent that stores the DHCP bindings database on a TFTP server can I load "recovery" the same database on the 2nd 6509 when there's a failure of the 1st catalyst ?
You can't configure DHCP pool for every VLAN, that's not what's design to do. YOu will have an external DHCP server that you could create all your DHCP scopes for each VLAN. then you need to add the ip helper statement at each VLAN on the switch.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...