cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
204
Views
0
Helpful
3
Replies

2 T1 PRI's

knmezi
Level 1
Level 1

PLEASE I NEED HELP MY 2 T1 PRI's I SETUP THE 2 PRIs WHICH WAS CONNECTED TO MY PBX, CONTROLLER T1 1/0 IS DOWN AND CONTROLLER T1 1/1 IS UP THE COFIGURATIONS FOR THE 2 TI PRIs LOOKS THE SAME BUT I DON'T KNOW WHAT IS THE PROBLEM. CAN ANY ONE HELP ME RESOLVING THIS PROBLEM.

3 Replies 3

spremkumar
Level 9
Level 9

hi

if u have already checked the cable by swapping between the controller card i would suggest to post the following o/ps here:

show version

show controllers

show run (config part related to controllers)

regds

I will post the info in the evenning but thank you for your care.

Knmezi.

spremkumar
Level 9
Level 9

hi

if u have already checked the cable by swapping between the controller card i would suggest to post the following o/ps here:

show version

show controllers

show run (config part related to controllers)

regds

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco