Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2501 serial ports and fractional t1 lines

This is going back and i can't remember if there is any configuration needed for defining the channels of a fractional t-1 circuit. Can someone tell if there is anything needed like on a t1 wic service-module command for defining the channels.

1 REPLY
New Member

Re: 2501 serial ports and fractional t1 lines

i solved my own problem. no commands needed. the CSU/DSU handles all of the channels.

92
Views
0
Helpful
1
Replies
CreatePlease to create content