Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

2502 seems to lock up?

Hi,

I just got 2 - 2502 routers off of eBay and after starting them up it seems to load up normally until it locks up. I can't figure out what's going on and it won't let me CTRL+BREAK or anything that would allow me to reconfigure the router. Can anyone help me with this, or atleast point me in the right direction? I've pasted a copy of what I get from the router.

Also, where can I find an updated IOS since I obviously did not buy my routers from cisco?

System Bootstrap, Version 5.2(8a), RELEASE SOFTWARE

Copyright (c) 1986-1995 by cisco Systems

2500 processor with 14336 Kbytes of main memory

F3: 7370472+108420+286116 at 0x3000060

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS s

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) 2500 Software (C2500-AINR-L), Version 11.2(17), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-1999 by cisco Systems, Inc.

Compiled Mon 04-Jan-99 17:55 by ashah

Image text-base: 0x03038204, data-base: 0x00001000

cisco 2500 (68030) processor (revision L) with 14336K/2048K bytes of memory.

Processor board ID 02968667, with hardware revision 00000000

Bridging software.

X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.

1 Token Ring/IEEE 802.5 interface(s)

2 Serial network interface(s)

32K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (Read ONLY)

Press RETURN to get started!

%LINK-3-UPDOWN: Interface Serial0, changed state to down

%LINK-3-UPDOWN: Interface Serial1, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface TokenRing0, changed state to dow

n

%SYS-5-CONFIG_I: Configured from memory by console

%SYS-5-RESTART: System restarted --

Cisco Internetwork Operating System Software

IOS (tm) 2500 Software (C2500-AINR-L), Version 11.2(17), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-1999 by cisco Systems, Inc.

Compiled Mon 04-Jan-99 17:55 by ashah

%LINK-5-CHANGED: Interface Serial1, changed state to administratively down

%LINK-5-CHANGED: Interface TokenRing0, changed state to administratively down

1 REPLY
VIP Purple

Re: 2502 seems to lock up?

Hello,

what are your configuration register settings ? Make sure it is 0x2102. To change it, hit Ctrl+Break within 10 seconds after booting the router, this will get you into ROMMOM mode. Change the configuration register to 0x2102 and reload the router.

HTH,

GP

74
Views
0
Helpful
1
Replies
CreatePlease to create content