I am trying to setup two Cisco 2511-RJ45 router / terminal server devices that will connect to each other on TTY / line async port. For ex. I would like to be able to make line one of TermServer 1 connect to line one on TermServer 2. Here is what I have so far as a confiugration
line 1 - (TermServer 1)
autocommand "connect IP address 4001" (where the ip address is replaced by the IP address of termserver 2 and the default port for line 1 on cisco is 4001)
Thanks...I have these thing set on the line. My real problem is getting the remote line to acknowledge that their is an incoming connection from the local termserver and keeping that connection established. Thanks for your help.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...