Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2514 will not hold config

We got 2 2514 routers back from one of our School districts that they had cleaned (erased the config)

Now when I try to add a config file everything goes fine, write mem seems to do its thing, everything looks great until you reboot it, it comes back up empty. I have never run into this before, it happens on both routers, Not sure what they did but I cannot even upgrade the IOS, because it loads the IOS then reboots and everything is gone.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 2514 will not hold config

Give a show version and see at the end, what the configuration register settings are. Check to see if its set to 0x2142. It needs to be changed back to 0x2102.

Router#Config t

Router(config)#config-register 0x2102

Router(config)#exit

Router#reload

2 REPLIES

Re: 2514 will not hold config

Give a show version and see at the end, what the configuration register settings are. Check to see if its set to 0x2142. It needs to be changed back to 0x2102.

Router#Config t

Router(config)#config-register 0x2102

Router(config)#exit

Router#reload

New Member

Re: 2514 will not hold config

That Worked like a charm Thanks !!!!

118
Views
0
Helpful
2
Replies
CreatePlease to create content