Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2600 Configuration Help

I need a quick education on how to save the running config on a 2600 router to the Startup Config. I tried the copy system:running-config nvram:startup-config command and when I restarted the system it still brought me back to the initial config. Any help would be appreciated.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: 2600 Configuration Help

Hi,

check the configurattion register value by "sh version" command. The configuration register value must be 0x2102. If not, make it 0x2102 and then make your config and save.

hope this helps..

3 REPLIES
Cisco Employee

Re: 2600 Configuration Help

Just do a "write mem" or "copy run start"

New Member

Re: 2600 Configuration Help

When I did that (wr mem) and powered down the router, It came back looking for the initial configuration dialog again. Help!!!!

New Member

Re: 2600 Configuration Help

Hi,

check the configurattion register value by "sh version" command. The configuration register value must be 0x2102. If not, make it 0x2102 and then make your config and save.

hope this helps..

253
Views
0
Helpful
3
Replies
CreatePlease to create content