I am setting up a perimeter internet router with two providers (AT&T & MCI). MCI is currently our primary provider. I currently am using just one interface, with ip address unnumbered on the serial referencing the public MCI address on the FastEthernet port.
I am going to switch this to:
Serial 1: -> MCI IP address(1); currently referenced to FE0/0
Serial 2: -> AT&T IP address
FastEthernet: -> MCI IP address(2)
Now will it cause problems if I have two of the following in my IOS config:
ip route 0.0.0.0 0.0.0.0 Serial1/0:0.1
ip route 0.0.0.0 0.0.0.0 Serial1/1:0.1
Or do you see any other issues I need to address? I am just trying to get the AT&T interface up for now; I will be adding load balancing and BGP later on.