I know this sounds crazy, but I just saw it and am curious if anyone else has. I had a 2610 router that I could telnet into and looked up and fine routing traffic, etc, however when I consoled into it, the router was in rommon???? Is this even possible? The only thing I can compare it to is a Linux box in a halted state that still runs processes in the background. Anyone?? Anyone??
Trust me I know this should not be possible... but I had a console connection open in rommon mode and in another window I opened a telnet conenction to the same router and it was normal. Once I rebooted, it was back to normal.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...