Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2600 Router First Time configuration

I have a 2000, linux, nt, novell network I am going to setup the 2 2600 for internet access please help to configure and allow access to these networks

1 REPLY
New Member

Re: 2600 Router First Time configuration

be happy to help, but you'll need to be a bit more specific.

The router won't care if you're running Linux, 2000, Novell, etc... It'll only care that you're running a network protocol like IP, IPX, NETBIOS...

I'm assuming that you're only running IP.

Are you using private IP addresses and connecting to the internet? if so, you'll need to run NAT on your router.

Do both routers connect to the internet from the same site or different sites?

Mick.

134
Views
0
Helpful
1
Replies
CreatePlease to create content