Does the 2620 Router have a default IP address? Cisco Tech support had us erase the info we had on our router and now we can't get in because we do not have the serial interface to get in it. We are in the process of getting one but it would help a great deal if the router had a default IP.
Dude, yer screwed.. If you were remotely attached to the router, whacked the config, and issued a reload you'll need someone to get on the console port and put a basic config on the router. They don't come up with any default IP addresses.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...