cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
203
Views
0
Helpful
1
Replies

2600 trunking to 2950 connected via wireless to 2950 trunked to 2600

b-felinski
Level 1
Level 1

I am having a problem which I think is due to the trunking. I have multiple vlans on each router trunked down to the 2950. One vlan is set up as a network between the two routers using a wireless solution. From router to router I can ping the interfaces, but I can't go from client to client on opposite sides of the wireless. I am using IGRP and all the information is found on each side.

2600 -> 2950 <--> 2950 <- 2600

Any help is greatly appreciated.

1 Reply 1

ciscomoderator
Community Manager
Community Manager

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: