You need the IP Plus software on the 2610. I would say, go for 12.2T.
For this IOS, you need 16 M flash. and 64 M memory. 10 percent of this memory is needed for Input/Output. (Packet memory)
With the existing configuration, it should do fine. Check how much is the CPU utilisation, right now, with eigrp/dlsw and transparent bridging on. You can use "show process cpu" for this. You can find out how much is the memory consumption using "show memory" command.
Note that you dont have an option to upgrade the memory to more than 64 Mb, because, 2610 can take only max of 64 (32 each).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.