2610 AUX port to Cisco 1601-R Synch/Async serial interface Backup
I have a Cisco2610 on my headquarter with E1 connection to Cisco 1601-R routers on branch offices. Cisco 1601 routers have WIC -1T for sync serial connection to headquarter. I want to backup serial lines with US Robotics modems with 2610 AUX port and 1601-R Sync/Async serial interface with PSTN. How can I configure it? Any sample config??? (I found configuration samples 2 AUX or 2 Async interface.)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...