2610 to 2924 Trunk ?

[rfyoung1]

I have a 2620 to 2920 using 802.1q to trunk working fine. I have tried to do the same with a 2610 and 2924 but with now luck. I am using the Latest 2924 code and 12.2-8t code on the router. Is a 10Mb full duplex trunk supported in this configuration ?

[a.manosca]

Trunking on routers require a FastEthernet interface.

That wouldn't be possible for a 2610 because it only has

a 10Mpbs ethernet port.

[Erick Bergquist]

Yes, it is possible to do 802.1q on a 2610 10 meg interface. IP PLUS feature set is needed. I'm doing it where I am with 12.0T code of some flavor.

IOS 12.0(1)T - feature added / introduced

IOS 12.1(3)T - native keyword added to encaps command

Before 12.1.3T the native VLAN has to be on the physical interface... (native vlan isn't tagged). Tagged VLANs put on subinterfaces.

[7rbowenii]

The code that allows trunking on the 2600 series router is correct, but in order to trunk you must have at least a 2620 router.

-Bo

[Tsasbrink]

ebergquist,

This is only the case for isl trunking, dotq is supported on 261x in certain iosses, i am using a 2611 with a 3500xl and dot1q trunking right as i type.