Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

2610 VLAN

I need to use a 2610 to route vlans. Can you tell me if the NM-16ESW-1GIG will allow me to configure the sub-interfaces I need on the GB port to create my vlans, or is that module just a basic layer 2 switch and has 1 Ip configured for the switch? There would be a 1000BTX-GBIC in my 3508, whcih would be the uplink/dot.1q trunk. Thanks for your help.

2 REPLIES
Gold

Re: 2610 VLAN

Re: 2610 VLAN

You can use. Configure the GIG port as trunk and use dot1q/ISL encap for the same. Use sub-interface for each VLAN to be connected onto this trunk.

88
Views
0
Helpful
2
Replies
CreatePlease to create content