Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2610XM router Ethernet interface

Do the Ethernet interfaces on the new 2600XM routers support 100Mb-Full Duplex settings? I think the old platform did not support this, but I wanted to confirm.

Thanks

Jericho

4 REPLIES
New Member

Re: 2610XM router Ethernet interface

Try going into the interface:

config t

interface F0/0 (for example) and try the command

speed 100

duplex full

If the router accepts the command then the interface will run at 100-Full

New Member

Re: 2610XM router Ethernet interface

I don't have the router yet, it's being considered for purchase. I'm asking because a felllow colleague mentioned an issue with setting the interface on the previous 2600 platform.

thanks

New Member

Re: 2610XM router Ethernet interface

I just looked at one of our "older" 2620 and we are running 100Mb/s Full-Duplex on the ethernet interface.

New Member

Re: 2610XM router Ethernet interface

Yes, it´s possible. i´m working recently with that and i could check it. the new 2600XM routers has a FastEthernet Interface and 100Mb-Full Duplex settings.

regards nad good luck with your purchase.

AS

235
Views
5
Helpful
4
Replies