I am trying to setup a 2611 as my gateway to the net. I have a static ip from my isp. I have the router configured so far with just the basic information, the ip address and routing protocal. Problem is, i can ping all the way up to my exeternal interface on the router from the inside network, but can seem to ping any outside address. (this happends even when i use ping from the router itself). Do i have to config. the router to point to my isp's dns servers? or would i just have to configure nat? i am trying to set up static nat but to no avail, can anyone give me a step by step example on how to set up nat? this is my first time doing this and i can't seem to find much information besides just an overview. thank you. - Gabe
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...