Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

2611 bandwidth control problem

Network Diagram

internet------s0-[2611]-e0------LAN

Leased line 1Mbps to Internet,i try to distribute bandwidth to

different application.example,ftp can use max 400Kbps.

yesterday,i try to use Class-Based Weighted Fair Queueing

do it ,but it only attach a service policy to the output interface

so,how can i control bandwidth to the 2611 input serial interface?

thanks.

  • Other Network Infrastructure Subjects
3 REPLIES
Bronze

Re: 2611 bandwidth control problem

Custom queuing is the best way to restrict bandwidth for certain protocols. See the following URL for more information -

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fqos_c/fqcprt2/qcfcq.htm

New Member

Re: 2611 bandwidth control problem

Hi,

You can use CAR for this.

access-list 120 tcp permit any any eq ftp

rate-limit input access-group 120 400000 50000 50000

This will do the needfull

Regards,

Homin

New Member

Re: 2611 bandwidth control problem

Hi

You can't control input trafic because it depond from the remote router and not from your's so you can only distribute out put trafic

TX

91
Views
0
Helpful
3
Replies