I have heard that you can configure a "menu" in a 2600 Router (used as a terminal server), the thing is like this: you telnet the Terminal server and the equipment display a menu and then with a selection in the menu you connect to one of the terminal server TTY lines or you can even "clear" any of the lines with this menu, could any body tell me if this is possible and how to do it?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...