Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

2612 Router & Lease Line

Hello. I have a Cisco 2612 router running a both ethernet and token ring segments. I have 4 remote sites that previously connected to the token ring via two-wire 56k analog lease lines, USR Courier modems and an old IBM Dials 8235 remote access unit. I need to bring these 4 sites into the ethernet segment and would prefer to use the lease lines that are already in place. Is it possible to get WIC cards or network modules to bring these sites straight into the router?? If so, what equipment would I need at the either end to accomodate this?? The system I'm using seems a little antiquated to me and there must be a better way to accomplish this. I'm fairly new to this, so bear with me if my question is not the most intelligent :)

Thank you,

Jeff

IntimidateU2@hotmail.com

1 REPLY
New Member

Re: 2612 Router & Lease Line

I apologize for not placing this in the appropriate forum as it is obviously better suited for the remote access forum. Perhaps next time I'll pay closer attention!

Thank you,

Jeff

103
Views
0
Helpful
1
Replies
CreatePlease to create content