Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2620 memory requirements

I have a 2620 with a 4 port ATM card for DSL customers. I need to upgrade to 12.1(5)YB to handle PPPoE. The requirements shows 16MB Flash and 64M DRAM.

My "sh version" shows the following:

System image file is "flash:c2600-is-mz.120-7.T.bin"

cisco 2620 (MPC860) processor (revision 0x102) with 59392K/6144K bytes of memory

.

Processor board ID JAD0428065E (1518940264)

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

1 FastEthernet/IEEE 802.3 interface(s)

4 ATM network interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

Note that the memory shows 59392K/6144K . Am I OK on the memory?

I am a little paranoid of doing this upgrade without being sure about the memory size.

Thanks in advance.

bob bloise

1 REPLY
New Member

Re: 2620 memory requirements

I have the answer, it was after 3:00AM when I posted that message. Yes, I was brain dead. :)

bob

107
Views
0
Helpful
1
Replies
CreatePlease to create content