I have a 2620 with a 4 port ATM card for DSL customers. I need to upgrade to 12.1(5)YB to handle PPPoE. The requirements shows 16MB Flash and 64M DRAM.
My "sh version" shows the following:
System image file is "flash:c2600-is-mz.120-7.T.bin"
cisco 2620 (MPC860) processor (revision 0x102) with 59392K/6144K bytes of memory
.
Processor board ID JAD0428065E (1518940264)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
4 ATM network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Note that the memory shows 59392K/6144K . Am I OK on the memory?
I am a little paranoid of doing this upgrade without being sure about the memory size.
Thanks in advance.
bob bloise
