Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2620 Router ( ver 12.0)

Hi

Am working on two Cisco 2620 routers and am having ISDN connection between these two.

The scenario goes this way:

Say I have got Host_1_2620 router connected to Host_2_2620 through ISDN BRI connection and am using dialer string command.

I am able to telnet to Host_2_2620 from Host_1_2620 but am not able to ping from Host_2_2620 to Host_1_2620 with its telnet session.

I am hereby attaching the "show version" of both the hosts.

Kindly give me a solution at the earliest.

1 REPLY
New Member

Re: 2620 Router ( ver 12.0)

What interface are you pinging? Try to ping the isdn interfaces from each other first. Make sure there is a route in the route table for the address you are pinging

show ip route x.x.x.x

If it says subnet not in table, then the problem is with your IGP (RIP,IGRP,EIGRP,OSPF etc) Under router add a Network x.x.x.x. Also try show ip protocols

216
Views
0
Helpful
1
Replies
CreatePlease to create content