10-29-2003 09:53 AM - edited 03-02-2019 11:20 AM
I have a 2620 and a 2620 XM both with WIC 1DSU T1 cards. I will be linking them via a point to point T1. The circuit was provisioned and were tested as B8ZS/ESF T1's. The T does not have any external IP addresses assigned to them. How do I set up the T1 interfaces? Can I assign them local addresses such as 192.168.128.22 and 192.168.128.23?
Thanks in advance,
Emjay
Solved! Go to Solution.
10-29-2003 03:46 PM
Yes you can assign private network address on the leased line.
http://www.cisco.com/warp/public/116/t1_wic1.html
set one end to clock source line, and the other end, to clock source internal.
HTH
10-29-2003 03:46 PM
Yes you can assign private network address on the leased line.
http://www.cisco.com/warp/public/116/t1_wic1.html
set one end to clock source line, and the other end, to clock source internal.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide