Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2620 T1 interface setup

I have a 2620 and a 2620 XM both with WIC 1DSU T1 cards. I will be linking them via a point to point T1. The circuit was provisioned and were tested as B8ZS/ESF T1's. The T does not have any external IP addresses assigned to them. How do I set up the T1 interfaces? Can I assign them local addresses such as 192.168.128.22 and 192.168.128.23?

Thanks in advance,

Emjay

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 2620 T1 interface setup

Yes you can assign private network address on the leased line.

http://www.cisco.com/warp/public/116/t1_wic1.html

set one end to clock source line, and the other end, to clock source internal.

HTH

1 REPLY

Re: 2620 T1 interface setup

Yes you can assign private network address on the leased line.

http://www.cisco.com/warp/public/116/t1_wic1.html

set one end to clock source line, and the other end, to clock source internal.

HTH

161
Views
0
Helpful
1
Replies
CreatePlease login to create content