Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2800 etherswitch module port security

Am trying to set up port-security on an etherswitch module port

when i put in switchport ?

i dont get the option port-security so i then cant use mac-address

so i thought about doing it via a mac based acl but again when i try to set up the interface for the mac based access list i dont get the option

(config-if)#mac ?

H.H.H MAC address

any one any ideas

Cheers for info

  • Other Network Infrastructure Subjects
3 REPLIES

Re: 2800 etherswitch module port security

Hi Friend,

Try this and see if it helps you

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t11/ft1636nm.htm#wp1433808

HTH, if yes please rate the post.

Ankur

Purple

Re: 2800 etherswitch module port security

Howdy,

You've gotta use this command:

mac-address-table secure vlan

You can ignore the vlan option if it's an access port.

Set the hw-address to the MAC address you want the port limited to...

Hope that helps - pls rate the post if it does.

Paresh

Bronze

Re: 2800 etherswitch module port security

Mark,

for port security to work, you need to configure the port as an access port first:

switchport mode access

Regards,

Nethelper

313
Views
0
Helpful
3
Replies