There are no external interfaces on the Cisco Unity Express hardware (physically there is an FE interface port, but it is disabled in software and unusable)all access must pass via the host router. The only local access to the Cisco Unity Express system is therefore via the host router's console interface. Access to Cisco Unity Express (via the router's command-line interface [CLI]) is only possible by using the following command:
service-Engine x/y session
This command requires Enable mode on the router and is therefore protected by the router's enable password settings. Although there is also an "enable" mode in the Cisco Unity Express module CLI, it has no password capability.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.