1. Do you know if the 2851 router can handle 40Mbit per seconed traffic without a delay? if not 3825 can do it?
2. I need to connect the router to 3 ethernent segment ( i can't use 802.1q ) so i must have 3 Ethernet port on the router. The 2851 has 2 built in ethernet port. Which WIC should i add in order to add another ethnernet port to the router? can i use the HWIC-4ESW ?
I must say that I could not find any hard numbers about the specified throughput either but as the 2851 has Gigabit interfaces there is little doubt in my mind that it will handle 40Mb/s without a problem. Platform througput was always mentioned in the past, no idea why they left it out. At least the datasheet does state that you may use the HWIC-4ESW module.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.