Anyone see where when you assign a vlan to one of the ports and you do a show vlan it only shows like the first 2 letters of the port , a show vlan would look like port f0 instead of f0/0/0 , it doesn't show the complete interface designation , even the ports left in default vlan 1 show up the same way as f0 . This must be a software bug , running 12.4.5b sp services code...
The router is truncating the display for some reason , just reads F0 where it should read F0/0/0 , seeing that there is 4 ports on the switchcard you really don't know what ports are in what vlan without having to do a "show run" command.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...