Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2924 switch access with http

I am having trouble accessing my 2924 switches through HTTP. I am using windows 2000 and internet explorer and have installed the java application needed. I am asked over and over again to enter a username and password while the graphics are loading. Any ideas?

Thanks.

3 REPLIES
Cisco Employee

Re: 2924 switch access with http

What username and password are you entering?

According to the instructions:

http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc5/scg/swcms.htm

When prompted for a username and password, enter only the switch enable password. CMS prompts you a second time for a username and password. Enter only the enable password again.

If you configure a local username and password, make sure you enable it by using the ip http authentication global configuration command. Enter your username and password when prompted.

hope this helps,

-Nairi

Cisco Employee

Re: 2924 switch access with http

Also, make sure the browser you are using is supported. You can verify that in the release-notes of the software running on the catalyst at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/index.htm

Blue

Re: 2924 switch access with http

Refer to the section 'Web Interface Keeps Asking Username and Password' at:

http://www.cisco.com/warp/public/473/59.html#webinterface for details on this.

I suspect that you're running into the defect CSCdv87375 listed in the above URL in the section 'Web Interface Keeps Asking Username and Password'

253
Views
0
Helpful
3
Replies
CreatePlease to create content