Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2924 switch - Erase command not visible

Erase command not visible

I have a 2924 switch (connected via a console port) which is being taken out of service. In enable mode I am unable to use the "erase" command. i.e it is not listed as a command when I do a ?.

I want to erase the config on the switch and return it to the stores. Anyone have any ideas?

Thanks in advance

EK

2 REPLIES
Cisco Employee

Re: 2924 switch - Erase command not visible

Purple

Re: 2924 switch - Erase command not visible

Just get into the switch in enable mode , type "write erase" and reload the switch , if asks you to save the config say no . Switch will be at factory defaults after reload .

214
Views
0
Helpful
2
Replies